LCR-II - Print a Calibration Ticket

Issue / Question :

  • This article will assist you in printing a calibration (diagnostic) ticket from an LCR-II register.
  • This procedure should always result in a printed ticket from the register and is a valuable troubleshooting tool used to ensure proper connection between the register and the printer.
  • It can also provide fault or diagnostic messages on the printed ticket that indicate issues at the register level.

Environment:

  • LCR-II

Resolution / Answer:

To print a calibration ticket please perform the following steps:

  1. Ensure that the register is cleared of any pending deliveries.
  2. Load a blank ticket into the printer.
  3. Flip the knob on the LCR-II to the SHIFT PRINT position for less than 2 seconds.
  4. Flip the knob on the LCR-II to the PRINT position.

It is imperative that the transition to the SHIFT PRINT position back to the PRINT position takes less than 2 seconds. If the knob is left on SHIFT PRINT for longer than two seconds, you will receive a shift ticket printout instead of a calibration ticket.


Comments

0 comments

Article is closed for comments.