Issue / Question :
- How do I adjust the Label and Form Feed Settings on a Zebra Printer?
Environment:
- Cargas Energy 2017 or Later
- Cargas Mobile Delivery
Resolution / Answer:
If you find that the Zebra printer is not stopping at a perforation with a black bar mark or if the feed button is not feeding a full label to the perforation, we recommend sending the following command block through Zebra Setup Utilities:
! U1 setvar "media.sense_mode" "bar"
! U1 setvar "media.feed_length" "2030"
! U1 do "device.reset" ""
The above will set the media type on the printer to use the bar sensor, it will set the feed length to encompass a full label, and will then reboot the printer.
Comments
Article is closed for comments.